Digi XBee SX 868 - MS (Missed Sync Messages); SQ (Missed Sleep Sync Count); Command Mode Options; CC (Command Sequence Character)

AT commands Command mode options
XBee® SX 868 RF Module User Guide
156
MS (Missed Sync Messages)
This command applies to the XBee SX 868 RF Module.
Reads the number of sleep or wake cycles since the device received a sync message.
Parameter range
[read-only]
Default
0
SQ (Missed Sleep Sync Count)
This command applies to the XBee SX 868 RF Module.
Counts the number of sleep cycles in which the device does not receive a sleep sync.
Set the value to 0 to reset this value.
When the value reaches 0xFFFF it does not increment anymore.
Parameter range
0 - 0xFFFF
Default
0
Command mode options
The following commands are Command mode option commands.
CC (Command Sequence Character)
This command applies to the XBee SX 868 RF Module.
Sets or displays the character the device uses between guard times of the Command mode sequence.
The Command mode sequence causes the device to enter Command mode.
Note We recommend using the a value within the rage of 0x20 - 0x7F as those are ASCII characters.
Parameter range
0 - 0xFF
Default
0x2B (the ASCII plus character:+)
CT (Command Mode Timeout)
This command applies to the XBee SX 868 RF Module.
Sets or displays the Command mode timeout parameter. If a device does not receive any valid
commands within this time period, it returns to Idle mode from Command mode.
Parameter range
2 - 0x1770 (x 100 ms)