Digi XBee SX 868 - Addressing Commands; SH (Serial Number High); Serial Number Low); DH (Destination Address High)

AT commands Addressing commands
XBee® SX 868 RF Module User Guide
122
Parameter range
0 - 7
Default
1
Addressing commands
The following AT commands are addressing commands.
SH (Serial Number High)
This command applies to the XBee SX 868 RF Module.
Displays the upper 32 bits of the unique IEEE 64-bit extended address assigned to the XBee in the
factory.
Parameter range
0 - 0xFFFFFFFF [read-only]
Default
Set in the factory
SL (Serial Number Low)
This command applies to the XBee SX 868 RF Module.
Displays the lower 32 bits of the unique IEEE 64-bit RF extended address assigned to the XBee in the
factory.
Parameter range
0 - 0xFFFFFFFF [read-only]
Default
Set in the factory
DH (Destination Address High)
This command applies to the XBee SX 868 RF Module.
Set or read the upper 32 bits of the 64-bit destination address. When you combine DH with DL, it
defines the destination address that the device uses for transmissions in Transparent mode.
0x000000000000FFFF is the broadcast address.
Parameter range
0 - 0xFFFFFFFF
Default
0
DL (Destination Address Low)
This command applies to the XBee SX 868 RF Module.