Digi XBee SX 868 - Remote at Command Response- 0 X97; Description

Frame descriptions Remote AT Command Response- 0x97
XBee® SX 868 RF Module User Guide
199
Remote AT Command Response- 0x97
Request frame:Remote AT Command Request - 0x17
Description
This frame type is emitted in response to aRemote AT Command Request - 0x17. Some commands
send back multiple response frames; for example, theNDcommand. Refer to individual AT command
descriptions for details on API response behavior.
This frame is only emitted if theFrame ID in the request is non-zero.
Format
The following table provides the contents of the frame. For details on frame structure, see API frame
format.
Offset Size Frame Field Description
0 8-bit Start
Delimiter
Indicates the start of an API frame.
1 16-bit Length Number of bytes between the length and checksum.
3 8-bit Frame type
Remote AT Command Response - 0x97
4 8-bit Frame ID
Identifies the data frame for the host to correlate with a prior
request.
5 64-bit 64-bit
source
address
The sender's 64-bit address.
13 16-bit Reserved
Unused, but this field is typically set to 0xFFFE.
15 16-bit
AT
command
The two ASCII characters that identify theAT Command.
17 8-bit Command
status
Status code for the host's request:
0x00 = OK
0x01 = ERROR
0x02 = Invalid command
0x03 = Invalid parameter
0x04 = Transmission failure
0x0C = Encryption error
18-n variable Parameter
value
(optional)
If the host requested a command parameter change, this field
will be omitted.
If the host queried a command by omitting the parameter
value in the request, this field will return the value currently set
on the device.
EOF 8-bit Checksum 0xFF minus the 8-bit sum of bytes from offset 3 tothis byte
(between length and checksum).