Regulatory information Europe (CE)
XBee® SX 868 RF Module User Guide
203
Europe (CE)
The XBee SX 868 RF Module has been tested for use in several European countries. For a complete list,
refer to www.digi.com/resources/certifications.
If XBee SX 868 RF Modules are incorporated into a product, the manufacturer must ensure compliance
of the final product with articles 3.1a and 3.1b of the Radio Equipment Directive. A Declaration of
Conformity must be issued for each of these standards and kept on file as described in the Radio
Equipment Directive.
Furthermore, the manufacturer must maintain a copy of the XBee SX 868 RF Module user guide
documentation and ensure the final product does not exceed the specified power ratings, antenna
specifications, and/or installation requirements as specified in the user guide.
CE and UKCA OEM labeling requirements
The CE and UKCA markings must be clearly visible and legible when you affix it to the product. If this
is not possible, you must attach these marks to the packaging (if any) or accompanying documents.
CE labeling requirements
The “CE” marking must be affixed to a visible location on the OEM product. The following figure shows
CE labeling requirements.
The CE mark shall consist of the initials “CE” taking the following form:
n
If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n
The CE marking must have a height of at least 5 mm except where this is not possible on
account of the nature of the apparatus.
n
The CE marking must be affixed visibly, legibly, and indelibly.
To Next Page
Loading...
