Digi XBee SX 868 - T8 (D8 Timeout); T9 (D9 Timeout); Q0 (P0 Timeout); Q1 (P1 Timeout)

AT commands I/O line passing commands
XBee® SX 868 RF Module User Guide
150
Specifies how long pin D7 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
T8 (D8 Timeout)
This command applies to the XBee SX 868 RF Module.
Specifies how long pin D8 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
T9 (D9 Timeout)
This command applies to the XBee SX 868 RF Module.
Specifies how long pin D9 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
Q0 (P0 Timeout)
This command applies to the XBee SX 868 RF Module.
Specifies how long pin P0 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0
Q1 (P1 Timeout)
This command applies to the XBee SX 868 RF Module.
Specifies how long pin P1 holds a given value before it reverts to configured value. If set to 0, there is
no timeout.