Digi XBee SX 868 - D8 (Dio8;Dtr;Sleep_Request); D9 (Dio9;On_Sleep)

AT commands I/O settings commands
XBee® SX 868 RF Module User Guide
137
Parameter Description
1
CTSflow control
2 N/A
3 Digital input
4 Digital output, low
5 Digital output, high
6 RS-485 Tx enable, low Tx (0 V on transmit, high when idle)
7 RS-485 Tx enable high, high Tx (high on transmit, 0 V when idle)
Default
0x1
D8 (DIO8/DTR/SLEEP_REQUEST)
This command applies to the XBee SX 868 RF Module.
Sets or displays the DIO8/SLEEP_REQUEST configuration (pin 10).
Parameter range
0, 1, 3 - 5
Parameter Description
0 Disabled
1 Sleep request
2 N/A
3 Digital input
4 Digital output, low
5 Digital output, high
Default
1
D9 (DIO9/ON_SLEEP)
This command applies to the XBee SX 868 RF Module.
Sets or displays the DIO9/ON_SLEEP configuration (pin 26).
Parameter range
0, 1, 3 - 6