Digi XBee SX 868 - P9 (Dio19;Spi_Attn); PD (Pull Up;Down Direction)

AT commands I/O settings commands
XBee® SX 868 RF Module User Guide
142
Parameter range
0, 1, 4, 5
Parameter Description
0 Disabled
1 SPI_SCLK
2 N/A
e N/A
4 Digital output low
5 Digital output high
Default
1
P9 (DIO19/SPI_ATTN)
This command applies to the XBee SX 868 RF Module.
Sets or displays the DIO19/SPI_ATTN configuration (pin 12).
Parameter range
0, 1, 4 - 6
Parameter Description
0 Disabled
1
SPI_ATTN
2 N/A
3 N/A
4 Digital output low
5 Digital output high
6 UART data present indicator
Default
1
PD (Pull Up/Down Direction)
This command applies to the XBee SX 868 RF Module.
The resistor pull direction bit field (1 = pull-up, 0 = pull-down) for corresponding I/O lines that are set
by the PR command.