Digi XBee SX 868 - Page 40

Get started Configure remote devices
XBee® SX 868 RF Module User Guide
40
These instructions show you how to configure the LT (Associated LED Blink Time) parameter on a
remote device.
1. Add two XBee devices to XCTU.
2. Configure the first device in APImode and name it XBEE_A.
3. Configure the second device in either API or Transparent mode, and name it XBEE_B.
4. Disconnect XBEE_B from your computer and remove it from XCTU.
5. Connect XBEE_B to a power supply (or laptop or portable battery).
The Radio Modules area should look something like this.
6.
Select XBEE_A and click the Discover radio nodes in the same network button .
7. Click Add selected devices in the Discovering remote devices dialog. The discovered remote
device appears below XBEE_A.
8. Select the remote device XBEE_B, and configure the following parameter:
LT: FF (hexidecimal representation for 2550 ms)
9.
Click the Write radio settings button .
The remote XBee device now has a different LED blink time.
10. To return to the default LED blink times, change the LT parameter back to 0 for XBEE_B.