DVR Server Manual
2.1.1 System setup
【Number of Channels】Display total channels of Local board card, the
number of IP Camera is not included. For IP Camera, you should set it
remotely in
IP Camera setup.
【Sensor Input(DI)】Display number of sensors (DI).
【Sensor output(DO)】Display the number of alarms(DO).
【Audio Monitoring】Select real-time monitoring audio or not.
【Use E-Map】Select use Electron Map or not.
【Camera sequencing interval】Set auto-split changing interval time.
【DI/DO Port】Select sensor/alarm driver connecting port, it must be
different from PTZ Port. If you do not use alarm input, you can close this
function. To avoid conflicts to the PTZ port, you should set and use the different
ports for these two functions.
【System Keystroke】System keystroke. When it is enable, functions of
some system keys will be disabled (Ctrl+Alt+Del included).
【Save Log for() Days】Log save days(max 100 days).
【POS Function】Set the pos function disable or not
【ACU Function】Set the ACU function disable or not
【Alarm camera popup interval】Set the interval of alarm camera, if you
select“—”,you can’t select function Start alarm popup.
【DI/DO Device】Select receive alarm device type. When you change the
type of alarm device, you should reboot the system to update the device
information in DI/DO control panel.
Note:
Currently, system supports following NV serials DI/DO devices: NV7608,
NV7609, NV7616, NV7616B, NV7632 and NV7632B. NV7632 includes two
NV7616 (or combination of NV 7608 and NV 7616), and NV7632B includes
two NV7616B. When you select these two selections you must set their
decoder address as 1 and 2, and they should connect with PC through RS 485
converter after they connect parallel with each other.
【Date Format】Select the way to display date. It decides the date display
mode of DVR system, including the information panel on the main screen, the
date panel of the playback window and OSD date in video.
【Alarm Beep】Select disable or enable from drop-down list. If select
“enable”, when there is an alarm, system will make beep voice.
【Time Format】Select time format from the drop-list. After you change
the format it will affect the OSD format, information in information display panel
and file lists.
【Default Camera type】Set the default mode of video from PAL and
To Next Page
Loading...