To Next PageTo Next Page
Need help?Do you have a question about the Dinstar MTG200 and is the answer not in the manual?
Provides a general introduction to the MTG200 E1/T1 trunk gateway and its capabilities.
Illustrates the typical deployment scenarios and connectivity of the MTG200 gateway.
Details the physical layout and interfaces of the MTG200 gateway, including front and rear views.
Lists the key features, physical interfaces, supported protocols, voice capabilities, and PSTN support.
Outlines essential preparations and precautions for installing the MTG200 gateway.
Guides through the physical connection steps for Ethernet and PSTN interfaces.
Explains how to prepare and connect E1/T1 cables, including RJ-48 joint creation.
Explains how to configure the IP address for the MTG200 gateway's network interfaces.
Details how to perform maintenance using the console port for configurations.
Provides steps to retrieve forgotten IP addresses using the console port.
Guides users through connecting the MTG200 to the network and logging into its web interface.
Describes the structure of the MTG200 web interface, including navigation and configuration panes.
Presents a visual flowchart of the typical configuration steps for the MTG200 gateway.
Provides an overview of the interface for monitoring system information, DTU status, and connection statuses.
Introduces common command-line interface commands for detailed gateway information and operations.
Introduces commands for configuring the gateway in config mode.
Introduces commands for using the ADA mode for specific operations.
General| Model | MTG200 |
|---|---|
| Category | Gateway |
| Protocols | SIP, TCP, UDP, RTP, SRTP, HTTP, HTTPS, ARP, ICMP, DNS, DHCP |
| Voice Codecs | G.711a/u, G.723.1, G.726, G.729A/B |
| Fax | T.38 |
| Signaling | SIP |
| Operating Temperature | 0°C to 40°C |
| Humidity | 10% - 90% Non-Condensing |
| Management | Web, Telnet, SSH |
