Dinstar MTG200 - Pri Config; PRI Parameter

MTG200 Trunk Gateway User Manual | Dinstar
34
Parameter
Explanation
802.1Q VLANx ID(0 -
4095)
The ID of VLAN of MTG200
802.1P Priority (0 - 7)
The priority of sending data. The larger digit, the higher
priority.
IP Address
The IP address of the MTG200 device in the VLAN
Subnet Mask
The subnet mask address of the MTG200 device in the
VLAN
Default Gateway
The default gateway of the VLAN
Primary DNS Server
The IP address of a Primary DNS Server
Secondary DNS Server
The IP address of a secondary DNS Server
VLANx MTU
The maximum size of package allowed to access VLAN
Note：
You need to restart the MTG200 device after finishing the configurations of
VLAN.
4.6 PRI Config
This menu manages the parameters related to the PRI. Before using the PRI, users need to check
whether the parameters match those of the remote end. Incorrectly matched parameters can cause
signaling or voice problems. The PRI parameters include the call number attribute settings and
other transmission settings, as well as the PRI D-channel settings, protocol type and interface
parameter attributes for each ports, which can cause signaling problems with PRI if the
parameters are incorrectly set.
4.6.1 PRI Parameter
Configure PRI parameters according to actual data which are provided by telecom operators.