Dinstar MTG200 - IP Trunk Status

MTG200 Trunk Gateway User Manual | Dinstar
23
4.4.5 IP Trunk Status
On the IP Trunk Status interface, the statuses of SIP trunks are displayed. The SIP trunks
need to be established at the SIP Config -> SIP Trunk interface first.
Parameter
Explanation
Trunk Name
This trunk name is the name used to register the SIP trunk. If
the SIP trunk is not registered, the trunk name is displayed as
“---”.
Trunk Mode
There are two trunk modes: peer (peer-to-peer) and access.
Incoming
Authentication Type
Incoming calls can be authenticated through password or IP
address.
Link Status
There are two link statuses: Established and Fault.