UltiMate 3000 RSLCnano – Standard Applications
4
1 Introduction
This document describes the standard setup, recommended experimental conditions and
testing procedures to run standard applications on the Thermo Scientific Dionex UltiMate
3000 RSLCnano system.
Notes: This document is intended for Thermo Fisher Scientific (or authorized)
service personnel as well as customers to assist in the installation and
system test of UltiMate 3000 RSLCnano systems.
It is assumed that the individual using this manual has sufficient training in
the installation and usage of analytical instrumentation and is aware of the
potential hazards including (but not limited to) electrical hazards, chemical
solvent hazards, exposure to UV radiation and the exposure to pressurized
solvents.
At various points throughout the manual, messages of particular importance are indicated by
the following symbols:
Tip: Indicates general information intended to optimize the installation and
setup steps or the performance of the instrument.
Important: Indicates that failure to take note of the accompanying information may
result in damage to the instrument.
Warning: Indicates that failure to take note of the accompanying information may
result in personal injury.
This manual is provided "as is." Every effort has been made to supply complete and accurate
information and all technical specifications have been developed with the utmost care. The
information contained in this manual should not be construed as a commitment by Thermo
Fisher Scientific. Thermo Fisher Scientific assumes no responsibility for any errors that may
appear in this document. This document is believed to be complete and accurate at the time of
publication. In no event shall Thermo Fisher Scientific be liable for incidental or
consequential damages in connection with or arising from the use of this document.
The information contained in this document is subject to change without notice.
To Next Page
Loading...
