DITEC CS12M - Display of Safety Devices and Commands

39
EN
IP2163EN
8.2 Display of safety devices and commands
The safety and command display mode is only visible with Display visualisation mode
set at 01 or 03.
Display Description
1-2 - Automatic closing command.
1-3 - Opening command.
1-4 - Closing command.
1-5 - Step-by-step command.
1-6 - Safety device with opening and closing stop.
1-8 - Safety with closing reversal.
1-9 - STOP command
P3 - Partial opening command.
3P - Opening command with operator present.
4P - Closing command with operator present.
RX - Radio reception (of any memorised key of a transmitter present in the
memory).
NX - Radio reception (of any non-memorised key).
→ →
→ →