9
EN
IP2163EN
Output
Value
Accessories
Description
AUX
SOFA1-SOFA2
GOPAV
LAN4S
LAB9
BIXLR12
BIXLR22
GOL868R4
The control panel has a housing for plug-in control and safe-
ty cards.
The action of the control card can be selected by selecting
→ .
If slot-in radio boards are used, remove the RDX module. The
display will show
.
WARNING: the plug-in cards must be inserted and removed
with the power supply disconnected.
RDX
ZENRS
ZENPRS
The control panel is fitted with a housing for factory-set ZENRS
(433.92 MHz) radio receiver type modules.
Can be replaced with a ZENPRS (868.35 MHz) radio receiver type
module.
Operating is selected by selecting
→ .
If slot-in radio boards are used, remove the RDX module. The
display will show
.
WARNING: the modules must be inserted and removed with the
power supply disconnected.
Mains power supply, motor, release microswitch and automa-
tion wiring connection (factory settings)
USB
The control panel has a USB input for connecting a USB
memory stick to update the FW or download diagnostic data.
It can also be connected to a PC for updates to the firm-
ware file which can be downloaded from the website www.
ditecentrematic.com using AMIGO software by way of a USB
Standard-A plug to Micro -B plug cable.
WARNING: disconnect the USB card and/or the ca-
ble from the USB input only whey you have set
→
→ . The display will show .
COM
BIXMR2
COM - This allows the functioning configurations to be saved
using the function
→ .
The saved configurations can be recalled using the function
→ .
COM - The storage module allows the remote controls to be
stored. If the control panel is replaced, the storage module being
used can be inserted in the new control panel.
WARNING: the storage module must be inserted and removed
with the power supply disconnected.
For further information refer to the NES100USB
kit manual.
To Next Page
Loading...
