dji MATRICE 3D Series - Page 34

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
34
©
2024 DJI All Rights Reserved.
DJI Pilot 2
App
1
2
Using DJI FlightHub 2
Open the DJI FlightHub 2 Project page, click >
> Action, and enable Remote Debugging; or
open the Devices page, click Dock > > Device Maintenance, and enable Remote Debugging
to open or close the dock cover.
If the dock cannot detect the aircraft, check whether the aircraft is on the landing pad by using
the dock livestream, and follow the instructions in DJI FlightHub 2. Click Force Close Dock Cover
if the aircraft is not on the landing pad. Click Close Dock Cover if the aircraft is on the landing
pad.
• When closing the dock cover, the aircraft will automatically power on, and the
propellers will slowly rotate to avoid damage to the propellers.
• When the aircraft battery level is low, the aircraft cannot power on to rotate and fold
the propellers and the dock cover cannot be closed remotely. To avoid this situation,
the dock will automatically close the dock cover when the battery level is below 6%,
and the aircraft will automatically power o when the battery level is below 3%.
• If the dock has no power supply, the aircraft cannot power on to rotate and fold the
propellers before closing the dock cover. In this case, DO NOT remotely open the dock
cover in DJI FlightHub 2. Otherwise, the dock cover cannot be closed.
• DO NOT click Force Close Dock Cover if the aircraft is on the landing pad. Otherwise,
the propellers and the dock cover may be damaged.
Using DJI Pilot 2
Connect the remote controller to the dock. Run DJI Pilot 2 and tap Open Dock Cover.