dji MATRICE 3D Series - Page 39

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
©
2024 DJI All Rights Reserved.
39
1. Return Vent and Supply Vent: Clean the return vent and the supply vent regularly to remove
any dust or debris.
2. Aircraft Orientation Marker: When placing the aircraft on the landing pad, make sure to align
the aircraft heading with the aircraft orientation marker. Otherwise, the aircraft may be
damaged.
3. RTK module: Make sure the landing pad is clear of obstacles and that the internal RTK
antennas are not covered. Otherwise, the signals will be obstructed and the positioning
performance will be aected.
4. Positioning Markers: There are four positioning markers on the landing pad for the aircraft
to identify the position of the dock.
• After the dock is powered on, DO NOT place any metal objects such as rings or any
electronic devices on the landing pad, or touch the landing pad surface when placing
the aircraft on the landing pad to avoid burns.
• The dock cannot charge the aircraft battery if metal foreign objects are detected on
the landing pad.
Air Conditioning System
The air conditioning system facilitates temperature adjustment inside the dock. When the dock
is in Idle status, the air conditioning system will automatically adjust the temperature inside the
dock, providing a suitable environment for the aircraft and the Intelligent Flight Battery.
After a flight task, the dock will start cooling when the ambient temperature exceeds
5° C (41° F) and the aircraft battery temperature exceeds 35° C (95° F). The dock will stop
cooling when the aircraft battery temperature drops below 30° C (86° F). If the aircraft battery
temperature cannot be detected, the temperature of the internal circulation supply vent will be
used as reference.
1
2
1
4
3
Landing Pad