dji MATRICE 3D Series - Page 38

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual
38
©
2024 DJI All Rights Reserved.
Temperature and Humidity Sensors
The dock features temperature and humidity sensors, which are used to measure external
temperature and the temperature and humidity inside the dock. The temperature and humidity
sensor inside the dock is shown in the diagram below.
Open the Devices page, click Dock > and enable Remote Debugging to view the temperature
and humidity information.
To ensure flight safety, the aircraft cannot take off when the external temperature is below
-20° C (-4° F). Flight tasks will be resumed after the external temperate is higher than -20° C
(-4° F).
Water Immersion Sensor
The dock features water immersion sensors, which can be used to detect whether the dock is
immersed in water. If a water immersion warning appears in DJI FlightHub 2, contact a qualied
electrician to disconnect the dock power supply and remove the water. If the dock works
properly, resume the dock power supply. If the dock fails to work properly, make sure to turn
o the AC power switch and backup battery switch, and contact DJI Support.