To Next Page

To Previous Page

DJI Dock 2/Matrice 3D Series Unmanned Aircraft Flight Manual

Status LED

Blinking Pattern Description

—

Solid Red Aircraft disconnected

Blinks red The temperature of the remote controller is too high, or the

battery level of the aircraft is low

—

Solid green Connected with the aircraft

Blinks blue The remote controller is linking to an aircraft

—

Solid yellow Firmware update failed

Blinks yellow The battery level of the remote controller is low

Blinks cyan Control sticks not centered

Battery Level LEDs

Blinking Pattern Battery Level

76%-100%

51%-75%

26%-50%

0%-25%

Remote Controller Alert

The remote controller vibrates or beeps twice continuously to indicate an error or warning. Pay

attention to the prompts that appear on the touchscreen or in DJI Pilot 2. Slide down from the

top of the screen and tap to mute. Note: After muting, all sounds of the remote controller

will be completely disabled, including related alarm sounds. Please use the mute function with

caution.

Optimal Transmission Zone

The signal between the aircraft and the remote controller is most reliable when the antennas

are positioned in relation to the aircraft as illustrated below.

The optimal transmission range is where the antennas are facing the aircraft, with the angle

between the antennas and the back of the remote controller being 180° or 270°.

dji MATRICE 3D Series Flight Manual

Other manuals for dji MATRICE 3D Series