ADJUSTABLE PEDALS
SWITCH
DESCRIPTION
The adjustable pedals switch is mounted on the
lower steering column cover/knee blocker (Fig. 4).
The adjustable pedals switch adjusts the adjustable
pedals fore-and-aft. The pedals move in the direction
the switch is actuated.
REMOVAL
(1) Disconnect battery negative (-) cable from bat-
tery and isolate.
(2) Remove fasteners securing lower steering col-
umn cover/knee blocker to instrument panel (Fig. 4).
(3) Disconnect switch wiring connector (Fig. 4),
then remove lower steering column cover/knee
blocker with adjustable pedal switch from vehicle.
(4) Remove fasteners securing switch to lower
steering column cover/knee blocker. Remove switch.
INSTALLATION
(1) Place switch in lower steering column cover/
knee blocker and install fasteners.
(2) Place lower steering column cover/knee blocker
below steering column and connect switch wiring
connector (Fig. 4).
(3) Install lower steering column cover/knee
blocker on instrument panel (Fig. 4). Install fasten-
ers.
(4) Connect battery negative (-) cable to battery.
(5) Check operation of adjustable pedals.
BRAKE FLUID LEVEL SWITCH
DESCRIPTION
The brake fluid level switch is located in the left
side of the brake fluid reservoir on the master cylin-
der. It is clipped into the reservoir. It can be removed
from the reservoir and replaced if necessary.
OPERATION
The purpose of the brake fluid level switch is to
provide the driver with an early warning that the
brake fluid level in the master cylinder reservoir has
dropped below an acceptable level.
As the fluid drops below the designed level, the
fluid level switch closes and grounds the red BRAKE
warning indicator circuit. This turns on the red
BRAKE warning indicator. At this time, the master
cylinder brake fluid reservoir must be checked and
filled to the FULL mark with brake fluid. Check the
entire brake hydraulic system for evidence of a leak.
CAUTION: An abnormal loss of brake fluid in the
master cylinder fluid reservoir could be caused by a
leak in the hydraulic system. The entire brake
hydraulic system should be checked for evidence
of a leak.
REMOVAL
NOTE: Before proceeding, review all Warnings and
Cautions. (Refer to 5 - BRAKES - WARNING)
(1) Remove vehicle wiring harness connector from
brake fluid level switch located in master cylinder
brake fluid reservoir (Fig. 5).
(2) Push together retaining tabs on opposite end of
switch (right side of reservoir), holding it in place in
brake fluid reservoir.
(3) Pull brake fluid level switch out of left side of
reservoir.
Fig. 4 Adjustable Pedals Switch
1 - REAR VIEW OF SWITCH
2 - LOWER STEERING COLUMN COVER
3 - WIRING CONNECTOR
4 - ADJUSTABLE PEDALS SWITCH
ZB BRAKES - BASE 5 - 9
To Next Page