Symptom:
PCI INTERNAL FAULT
When Monitored and Set Condition:
PCI INTERNAL FAULT
When Monitored: With the ignition in the run position.
Set Condition: The DTC will set if the BCM detects a PCI internal fault.
POSSIBLE CAUSES
PCI INTERNAL FAULT
TEST ACTION APPLICABILITY
1 Connect the DRB to the Data Link Connector.
Turn the ignition on.
With the DRB, erase BCM DTC’s.
Turn the ignition off then turn the ignition on.
With the DRB, read BCM DTC’s.
Did this DTC reset?
All
Yes → Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No → Test Complete.
152
COMMUNICATION
To Next Page
Loading...
