Symptom:
DECKLID RELEASE OUTPUT OPEN
When Monitored and Set Condition:
DECKLID RELEASE OUTPUT OPEN
When Monitored: Whenever the Decklid Release is activated.
Set Condition: The Body Control Module supplies the current to the Decklid Release
Solenoid when the command to release is received. If the Release Driver current draw is
less than 0.1 amp when the output is turned on, this code will set.
POSSIBLE CAUSES
DTC PRESENT
GROUND CIRCUIT
DECKLID RELEASE SOLENOID
DECKLID RELEASE DRIVER WIRE OPEN
BODY CONTROL MODULE - DECKLID RELEASE DRIVER OPEN
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Decklid Release several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display DECKLID RELEASE OUTPUT OPEN?
All
Yes → Go To 2
No → The condition that caused the code to set is not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
2 Disconnect the Decklid Release Solenoid.
Using a 12-volt test light connected to 12-volts, check the Ground circuit at the
solenoid connector.
Does the test light illuminate brightly?
All
Yes → Go To 3
No → Repair the Ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
291
POWER DOOR LOCKS/RKE
To Next Page
Loading...
