Dodge ZB 2005 - Headlamp Washer Relay Short to Battery (Export Only)

Symptom:
HEADLAMP WASHER RELAY SHORT TO BATTERY (EXPORT
ONLY)
When Monitored and Set Condition:
HEADLAMP WASHER RELAY SHORT TO BATTERY (EXPORT ONLY)
When Monitored: With the Ignition On.
Set Condition: This DTC will set if the BCM senses an over current condition on the
Headlamp Washer Pump Relay Control circuit.
POSSIBLE CAUSES
DTC PRESENT
FAULTY HEADLAMP WASHER PUMP RELAY
HEADLAMP WASHER PUMP RELAY CONTROL CIRCUIT SHORT TO VOLTAGE
BODY CONTROL MODULE
TEST ACTION APPLICABILITY
1 With the DRBIIIt, record and erase DTC’s.
With the DRBIIIt, read DTC’s.
Attempt to operate the Headlamp Washers while monitoring the DRBIIIt.
Does the DRBIIIt display HEADLAMP WASHER RELAY SHORT TO BATTERY?
All
Yes → Go To 2
No → The condition that caused this DTC to set iscurrently not present.
Using the wiring diagram/schematic as a guide, inspect the
related wiring harness and connectors for a possible intermittent
condition.
Perform BODY VERIFICATION TEST - VER 1.
2 Turn the ignition OFF.
Disconnect the Body Control Module C4 connector.
Disconnect the Headlamp Washer Pump Relay.
Turn the ignition ON.
Measure the voltage between ground and the Headlamp Washer Relay Control
circuit.
Is the voltage above 5.0 volts?
All
Yes → Repair the Headlamp Washer Pump Relay Control circuit for a
short to voltage.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 3
401
WINDSHIELD WIPER & WASHER