Symptom:
PASSENGER WINDOW UP SHORT TO GROUND
When Monitored and Set Condition:
PASSENGER WINDOW UP SHORT TO GROUND
When Monitored: Whenever the ignition is in the Run or Accessory position and the
passenger window up switch is actuated..
Set Condition: When the BCM turns on the Passenger Window Up Relay Control circuit
and detects a current draw over 250 ma. for over 125 milliseconds, this code will set.
POSSIBLE CAUSES
DTC PRESENT
RELAY SHORTED
PASSENGER WINDOW UP RELAY CONTROL WIRE SHORT TO GROUND
BODY CONTROL MODULE - PASSENGER WINDOW UP RELAY CONTROL SHORTED
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Passenger Window Motor several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display PASSENGER WINDOW UP SHORTED TO GROUND?
All
Yes → Go To 2
No → The condition that caused the code to set is not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
2 Remove the Passenger Window Up Relay.
Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Press the Passenger Window Switch several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display PASSENGER WINDOW UP SHORTED TO GROUND?
All
Yes → Go To 3
No → Replace the Window Relay.
Perform BODY VERIFICATION TEST - VER 1.
363
POWER WINDOWS
To Next Page
Loading...
