Dodge ZB 2005 - Driver Seat Belt Switch Short to Battery

Symptom:
DRIVER SEAT BELT SWITCH SHORT TO BATTERY
When Monitored and Set Condition:
DRIVER SEAT BELT SWITCH SHORT TO BATTERY
When Monitored: With the ignition on the ACM monitors the Seat Belt Buckle Switch
circuit for an short to battery.
Set Condition: The code will set if the ACM detects high circuit voltage.
POSSIBLE CAUSES
DRIVER SEAT BELT SWITCH SHORT TO BATTERY
DRIVER SEAT BELT SWITCH CIRCUITS SHORT TO BATTERY
ACM, DRIVER SEAT BELT SWITCH SHORT TO BATTERY
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST ACTION APPLICABILITY
1 NOTE: Ensure that the battery is fully charged.
Turn the ignition on.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
All
ACM - ACTIVE DTC
Go To 2
ACM - STORED DTC
Go To 4
2 Turn the ignition off.
Disconnect the Driver Seat Belt Switch.
NOTE: Check connectors - Clean and repair as necessary.
Turn the ignition on.
With the DRBIIIt, read the active Airbag DTCs.
Does the DRB show DRIVER SEAT BELT SWITCH CIRCUIT OPEN?
All
Yes → Replace the Driver Seat Belt Switch Buckle Assembly.
Perform AIRBAG VERIFICATION TEST - VER 1.
No → Go To 3
36
AIRBAG