Symptom:
DRIVER WINDOW DOWN OUTPUT SHORT TO GROUND
When Monitored and Set Condition:
DRIVER WINDOW DOWN OUTPUT SHORT TO GROUND
When Monitored: Whenever the ignition is in the Run or Accessory position.
Set Condition: When the BCM turns on the Driver Window Down circuit and detects a
voltage of less than 0.5 volts for over 125 milliseconds, this code will set.
POSSIBLE CAUSES
DTC PRESENT
MOTOR SHORTED
DRIVER WINDOW DOWN DRIVER WIRE SHORT TO GROUND
BODY CONTROL MODULE -DRIVER WINDOW DOWN DRIVER SHORTED
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Driver Window Motor several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display DRIVER WINDOW DOWN CIRCUIT SHORT TO
GROUND?
All
Yes → Go To 2
No → The condition that caused the code to set is not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
2 Disconnect the Driver Window Motor connector.
Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Press the Driver Window Switch DOWN several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display DRIVER WINDOW DOWN SHORTED TO GROUND?
All
Yes → Go To 3
No → Replace the Window Motor.
Perform BODY VERIFICATION TEST - VER 1.
337
POWER WINDOWS
To Next Page
Loading...
