Dodge ZB 2005 - Exhaust Relay Short to Battery (Export Only)

Symptom:
EXHAUST RELAY SHORT TO BATTERY (EXPORT ONLY)
When Monitored and Set Condition:
EXHAUST RELAY SHORT TO BATTERY (EXPORT ONLY)
When Monitored: With the Ignition On.
Set Condition: This DTC will set if the BCM senses an over current condition on the
Exhaust Relay Control circuit.
POSSIBLE CAUSES
DTC PRESENT
EXHAUST RELAY CONTROL CIRCUIT SHORT TO VOLTAGE
FAULTY EXHAUST RELAY
BODY CONTROL MODULE
TEST ACTION APPLICABILITY
1 With the DRBIIIt, record and erase DTC’s.
With the DRBIIIt, read DTC’s.
Attempt to operate the Exhaust Relay while monitoring the DRBIIIt.
Does the DRBIIIt display EXHAUST RELAY SHORT TO BATTERY?
All
Yes → Go To 2
No → The condition that caused this DTC to set iscurrently not present.
Using the wiring diagram/schematic as a guide, inspect the
related wiring harness and connectors for a possible intermittent
condition.
Perform BODY VERIFICATION TEST - VER 1.
2 Turn the ignition OFF.
Disconnect the Body Control Module C4 connector.
Disconnect the Exhaust Relay.
Turn the ignition ON.
Measure the voltage between ground and the Exhaust Relay Control circuit.
Is the voltage above 5.0 volts?
All
Yes → Repair the Exhaust Relay Control circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 3
3 With the ignition OFF.
Measure the coil side resistance of the Exhaust Relay.
Is the resistance between 85.0 and 106.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Exhaust Relay.
Perform BODY VERIFICATION TEST - VER 1.
260
IGNITION, POWER, ACCESSORY