Symptom:
COUNTRY CODE NOT PROGRAMMED
When Monitored and Set Condition:
COUNTRY CODE NOT PROGRAMMED
When Monitored: Continuously.
Set Condition: The BCM does not learn the country code within 10 seconds. DRL will
become enabled until country code is programmed.
POSSIBLE CAUSES
SELECT CORRECT COUNTRY CODE
TEST ACTION APPLICABILITY
1 With the DRB, enter Body Computer, Miscellaneous then Change Country Code.
Select the correct country code for the vehicle.
With the DRB, erase BCM DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRB, read BCM DTC’s.
Did this DTC reset?
All
Yes → Replace the Body Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No → Test Complete.
148
COMMUNICATION
To Next Page
Loading...
