Symptom:
PASSENGER WINDOW DOWN RELAY COIL SHORT TO BATTERY
When Monitored and Set Condition:
PASSENGER WINDOW DOWN RELAY COIL SHORT TO BATTERY
When Monitored: Whenever the ignition is in the Run or Accessory position and the
window switch is activated down..
Set Condition: When the BCM grounds the Passenger Window Down Relay Control
circuit and detects a current greater than approximately 250 ma. for over 125 milliseconds,
this code will set.
POSSIBLE CAUSES
DTC PRESENT
RELAY SHORTED
PASSENGER WINDOW DOWN RELAY CONTROL WIRE SHORT TO BATTERY
BODY CONTROL MODULE - PASSENGER WINDOW DOWN RELAY CONTROL SHORTED
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Passenger Window Motor several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display PASSENGER WINDOW DOWN SHORTED TO BAT-
TERY?
All
Yes → Go To 2
No → The condition that caused the code to set is not present at this
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
2 NOTE: The Passenger Window Down Relay is located left of the steering
column and taped to the harness.
Remove the Passenger Window Down Relay.
Install a substitute Relay in place of the Passenger Window Down Relay.
Turn the ignition on.
With the DRBIIIt, erase DTCs.
Cycle the ignition switch from Off to Run.
Press the Passenger Window Switch DOWN several times.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display PASSENGER WINDOW DOWN SHORTED TO BAT-
TERY?
All
Yes → Go To 3
No → Replace the Window Relay.
Perform BODY VERIFICATION TEST - VER 1.
351
POWER WINDOWS
To Next Page
Loading...
