TEST ACTION APPLICABILITY
3 Disconnect the Decklid Release Solenoid.
Using a 12-volt test light connected to ground, check the Decklid Release Driver
circuit at the solenoid connector..
Turn the ignition on.
Try to operate the Decklid Release several times.
Does the test light illuminate brightly when the decklid is activated?
All
Yes → Replace the Decklid Release Solenoid.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 Turn the ignition off.
Disconnect the Decklid Release Solenoid connector.
Disconnect the BCM C2 harness connector.
Measure the resistance of the Decklid Release Driver circuit between the BCM C2
connector and the Solenoid connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Decklid Release Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
292
POWER DOOR LOCKS/RKE
DECKLID RELEASE OUTPUT OPEN — Continued
To Next Page
Loading...
