TEST ACTION APPLICABILITY
4 Turn the ignition off.
Reconnect the BCM if disconnected in previous step.
Disconnect the Instrument Cluster harness connectors.
Turn the ignition on.
With the DRBIIIt, actuate the CHIME. (BCM actuator)
Using a 12-volt test light connected to 12-volts, check the chime driver circuit at the
Instrument Cluster connector.
Does the test light illuminate ON and OFF?
All
Yes → Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 5
5 Turn the ignition off.
Disconnect the Instrument Cluster harness connectors.
Disconnect the BCM harness connector(s).
Measure the resistance of the chime driver circuit between the Instrument Cluster
connector and the BCM connector.
Is the resistance below 5.0 ohms?
All
No → Repair the chime driver circuit for an open, between the Instru-
ment Cluster and the BCM.
Perform BODY VERIFICATION TEST - VER 1.
Yes → Replace the BCM.
Perform BODY VERIFICATION TEST - VER 1.
144
CHIME
*CHIME INOPERATIVE — Continued
To Next Page
Loading...
