TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Left High Beam Headlamp connector.
Turn the ignition on.
Turn the High Beams on.
Using a 12-volt test light connected to ground, check the Left High Beam Output
circuit.
Does the test light illuminate brightly?
All
Yes → Replace the High Beam Headlamp.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
190
EXTERIOR LIGHTING
LEFT HIGH BEAM OUTPUT SHORT — Continued
To Next Page
Loading...
