TEST ACTION APPLICABILITY
4 Turn the ignition off.
Remove the Headlamp Relay from the Power Distribution Center.
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Headlamp Relay Control circuit at the Headlamp
Relay connector to ground.
Is the resistance below 5.0 ohms?
All
Yes → Repair the Headlamp Relay Control circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 5
5 Turn the ignition off.
Remove the Headlamp Relay from the Power Distribution Center.
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Headlamp Relay Control circuit between the BCM
connector and the Headlamp Relay connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Headlamp Relay Control circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
192
EXTERIOR LIGHTING
LOW BEAM RELAY COIL OUTPUT OPEN/SHORT TO GROUND —
Continued
To Next Page
Loading...
