TEST ACTION APPLICABILITY
9 Turn the ignition off.
Disconnect the Blower Motor harness connector.
Disconnect the A/C - Heater Control Module C1 harness connector.
Measure the resistance of the Blower Motor High Driver circuit between the Blower
Motor harness connector and theA/C - Heater Control Module C1 harness connector.
Is the resistance below 5 ohms?
All
Yes → Replace the Blower Motor in accordance with the Service Infor-
mation.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Blower Motor High Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
232
HEATING & A/C
*BLOWER MOTOR INOPERATIVE — Continued
To Next Page
Loading...
