TEST ACTION APPLICABILITY
3 Turn the Ignition off.
Remove the Accessory Relay from the PDC.
Disconnect the Body Control Module C4 connector.
Measure the resistance of the Accessory Relay Control circuit between the BCM C4
connector and the Relay connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 4
No → Repair the Accessory Relay Control circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
4 If there are no possible causes remaining, view repair. All
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
239
IGNITION, POWER, ACCESSORY
BCM - ACCESSORY RELAY CONTROL CIRCUIT OPEN — Continued
To Next Page
Loading...
