TEST ACTION APPLICABILITY
2 NOTE: All modules and components identified in Test Number 1 must be
disconnected from the BCM’s circuits and the DTC must still be present for
the result of the test to be valid.
Turn the ignition off.
Disconnect the appropriate module or component harness connector.
Disconnect the BCM C3 and C4 harness connectors.
Using the wiring diagram/schematic as a guide, measure the resistance between
ground and the appropriate circuit in the BCM harness connectors.
Is the resistance below 10k ohms on any of the circuits?
All
Yes → Repair the appropriate Run 1 circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and program the Body Control Module in accordance
with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
248
IGNITION, POWER, ACCESSORY
BCM - IGNITION RUN 1 SHORT — Continued
To Next Page
Loading...
