TEST ACTION APPLICABILITY
2 NOTE: All components identified in Test Number 1 must be disconnected
from the BCM’s Fused Ignition Switch Output (Run) circuit and the DTC
must still be present for the result of the test to be valid.
Turn the ignition off.
Disconnect the BCM C2 harness connector.
Measure the resistance between ground and the Fused Ignition Switch Output (Run)
circuits in the BCM C2 harness connector.
Using the wiring diagram/schematic as a guide, disconnect the appropriate compo-
nent harness connector.
Is the resistance below 10k ohms on any of the circuits?
All
Yes → Repair the Fused Ignition Switch Output (Run) circuit for a short
to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and program the Body Control Module in accordance
with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
250
IGNITION, POWER, ACCESSORY
BCM - IGNITION RUN 2 SHORT — Continued
To Next Page
Loading...
