TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the BCM C2 harness connector.
Disconnect the Ignition Switch harness connector.
Measure the resistance of theIgnition Switch Output (Run-Start) circuitbetween the
BCM C2 connector and the Ignition Switch connector.
Is the resistance above 5.0 ohms?
All
Yes → Repair the Fused Ignition Switch Output (Run-Start) circuit for
an open. If the fuse is open make sure to check for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and program the Body Control Module in accordance
with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
257
IGNITION, POWER, ACCESSORY
BCM - RUN/START HARDWIRE INPUT MISMATCH — Continued
To Next Page
Loading...
