TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Body Control Module C2 connector.
Remove the Horn Relay from the Power Distribution Center.
Turn the ignition On.
Measure the voltage of the Horn Relay Control circuit at the relay.
Is the voltage above 10.0 volts?
All
Yes → Repair the Horn Relay Control circuit for a short to voltage.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
264
IGNITION, POWER, ACCESSORY
HORN RELAY COIL SHORT TO BATTERY — Continued
To Next Page
Loading...
