TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Fuel Pump Module harness connector.
Disconnect the BCM C3 harness connector.
Measure the resistance between ground and the Fuel Level Sensor Signal circuit.
Is the resistance below 5.0 ohms?
All
Yes → Repair the Fuel Level Sensor Signal circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
276
INSTRUMENT CLUSTER
BCM - FUEL LEVEL SENDING UNIT INPUT SHORT TO GROUND —
Continued
To Next Page
Loading...
