TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Decklid Release Solenoid connector.
Disconnect the BCM C2 harness connector.
Measure the resistance between ground and the Decklid Release Driver circuit.
Is the resistance below 1000.0 ohms?
All
Yes → Repair the Decklid Release Driver circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
294
POWER DOOR LOCKS/RKE
DECKLID RELEASE OUTPUT SHORT TO GROUND — Continued
To Next Page
Loading...
