Dodge ZB 2005 - Page 1677

TEST ACTION APPLICABILITY
3 Disconnect the Driver Cylinder Unlock Switch connector.
Measure the voltage between Driver Cylinder Unlock Switch Mux circuit and
ground.
Select the voltage present.
All
Below 4.0 volts.
Repair the DriverCylinder Unlock Switch Mux circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
Between 4.1 volts and 5.2 volts.
Replace the Cylinder Unlock Switch.
Perform BODY VERIFICATION TEST - VER 1.
Above 5.3 volts.
Go To 4
4 Disconnect the Driver Cylinder Unlock Switch connector.
Disconnect the Body Control Module C3 connector.
NOTE: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Turn the park lamps on.
Measure the voltage between Driver Cylinder Unlock Switch Mux circuit and
ground.
Is there any voltage present?
All
Yes → Repair the Driver Cylinder Unlock Switch Mux circuit for a short
to voltage.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
296
POWER DOOR LOCKS/RKE
DRIVER CYLINDER UNLOCK SWITCH OPEN OR SHORT TO VOLTAGE
—
Continued