TEST ACTION APPLICABILITY
3 Disconnect the Driver Cylinder Unlock Switch connector.
Disconnect the Body Control Module C3 connector.
Measure the resistance between Driver Cylinder Unlock Switch Mux circuit and
ground.
Is the resistance below 1000.0 ohms?
All
Yes → Repair the Driver Cylinder Unlock Switch Mux circuit for a short
to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 If there are no possible causes remaining, view repair. All
Repair
Disconnect the BCM harness connector(s). Check connectors -
Clean/repair as necessary. If okay, replace the Body Control
Module.
Perform BODY VERIFICATION TEST - VER 1.
298
POWER DOOR LOCKS/RKE
DRIVER CYLINDER UNLOCK SWITCH SHORT TO GROUND — Continued
To Next Page
Loading...
