Dodge ZB 2005 - Page 1683

TEST ACTION APPLICABILITY
3 Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between the Driver Door Switch Mux circuit and the Driver
Door Switch Return circuits in the BCM C2 and C3 connectors.
Is the resistance below 200.0 ohms?
All
Yes → Go To 4
No → Go To 7
4 Disconnect the Body Control Module C2 and C3 connectors.
Disconnect the Driver Door Lock Switch connector.
Measure the resistance between the Driver Door Switch Mux circuit and the Driver
Door Switch Return circuit in the BCM C2 and C3 connectors.
Is the resistance below 200 ohms?
All
Yes → Go To 5
No → Replace the Driver Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
5 Disconnect the Body Control Module C2 and C3 connectors.
Disconnect the Driver Interior Door Handle Switch connector.
Measure the resistance between the Driver Door Switch Mux circuit and the Driver
Door Switch Return circuit in the BCM C2 and C3 connectors.
Is the resistance below 200 ohms?
All
Yes → Go To 6
No → Replace the Driver Interior Door Handle Switch.
Perform BODY VERIFICATION TEST - VER 1.
6 If there are no possible causes remaining, view repair. All
Repair
Repair the Driver Door Switch Mux wire for a short to the Driver
Door Switch Return wire.
Perform BODY VERIFICATION TEST - VER 1.
7 If there are no possible causes remaining, view repair. All
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
302
POWER DOOR LOCKS/RKE
DRIVER DOOR LOCK CIRCUIT SHORT TO GROUND — Continued