TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between ground and the Driver Door Switch Mux circuit in
the BCM C3 connector.
Is the resistance below 10000.0 (10K) ohms?
All
Yes → Repair the Driver Door Switch Mux circuit for a partial short to
ground
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 Turn the ignition off.
Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between Driver Door Switch Mux circuit and the Driver Door
Switch Return circuit in the BCM C3 and C2 connectors.
Is the resistance below 10000.0 (10K) ohms?
All
Yes → Repair the Driver Door Switch Mux circuit for a short to the
Driver Door Switch Return circuit.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
304
POWER DOOR LOCKS/RKE
DRIVER DOOR LOCK SWITCH STUCK — Continued
To Next Page
Loading...
