Dodge ZB 2005 - Page 1690

TEST ACTION APPLICABILITY
3 Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between ground and the Driver Door Switch Mux circuit in
the BCM C3 connector.
Is the resistance below 10000.0 (10K) ohms?
All
Yes → Repair the Driver Door Switch Mux circuit for a partial short to
ground
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between the Driver Door Switch Mux circuit and the Driver
Door Switch Return circuits in the BCM C2 and C3 connectors.
Is the resistance below 10000.0 (10K) ohms?
All
Yes → Repair the Driver Door Switch Mux circuit for a partial short to
the Driver Door Switch Return circuit.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
309
POWER DOOR LOCKS/RKE
DRIVER INTERIOR DOOR HANDLE SWITCH STUCK — Continued