Dodge ZB 2005 - Page 1694

TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Body Control Module C3 and C4 connectors.
Measure the resistance between ground and the Passenger Door Switch Mux circuit
in the BCM C3 connector.
Is the resistance below 10000.0 (10K) ohms?
All
Yes → Repair the Passenger Door Switch Mux circuit for a partial short
to ground
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 Turn the ignition off.
Disconnect the Body Control Module C3 and C4 connectors.
Measure the resistance between the Passenger Door Switch Mux circuit and the
Passenger Door Switch Return circuits in the BCM C3 and C5 connectors.
Is the resistance below 10000.0 (10K) ohms?
All
Yes → Repair the Passenger Door Switch Mux circuit for a partial short
to the Passenger Door Switch Return circuit.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
313
POWER DOOR LOCKS/RKE
PASSENGER DOOR LOCK SWITCH STUCK — Continued