TEST ACTION APPLICABILITY
9 Disconnect the inoperative Driver Handle Switch connectors.
Measure the voltage of the Driver Door Switch Mux circuit in the Driver Handle
Switch connector.
Is the voltage above 4.5 volts?
All
Yes → Go To 10
No → Repair the Driver Door Switch Mux circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
10 If there are no possible causes remaining, view repair. All
Repair
Replace the Driver Handle Switch.
Perform BODY VERIFICATION TEST - VER 1.
11 Disconnect the Power Door Lock Switch connector.
Using a 12-volt test light connected to 12-volts, check the Driver Door Switch Return
circuit.
Does the test light illuminate brightly?
All
Yes → Go To 12
No → Repair the Driver Door Switch Return circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
12 Disconnect the Driver Door Lock Switch connectors.
Measure the voltage of the Driver Door Switch Mux circuit.
Is the voltage above 4.5 volts?
All
Yes → Go To 13
No → Repair the Driver Door Switch Mux circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
13 If there are no possible causes remaining, view repair. All
Repair
Replace the Driver Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
327
POWER DOOR LOCKS/RKE
*DRIVER DOOR SWITCH OR SWITCHES INOPERATIVE — Continued
To Next Page
Loading...
