Dodge ZB 2005 - Page 1713

TEST ACTION APPLICABILITY
11 Disconnect the Power Door Lock Switch connector.
Using a 12-volt test light connected to 12-volts, check the Passenger Door Switch
Return circuit.
Does the test light illuminate brightly?
All
Yes → Go To 12
No → Repair the Passenger Door Switch Return circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
12 Disconnect the Passenger Door Lock Switch connectors.
Measure the voltage of the Passenger Door Switch Mux circuit.
Is the voltage above 4.5 volts?
All
Yes → Go To 13
No → Repair the Passenger Door Switch Mux circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
13 If there are no possible causes remaining, view repair. All
Repair
Replace the Passenger Door Lock Switch.
Perform BODY VERIFICATION TEST - VER 1.
332
POWER DOOR LOCKS/RKE
*PASSENGER DOOR SWITCH OR SWITCHES INOPERATIVE — Continued