TEST ACTION APPLICABILITY
7 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C3 harness connector.
Measure the resistance between ground and the Driver Window Hall Signal circuit.
Is the resistance below 1000.0 ohms?
All
Yes → Go To 8
No → Repair the Driver Window Hall Signal circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
8 If there are no possible causes remaining, view repair. All
Repair
Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
9 Turn the ignition off.
Disconnect the Window Motor connector.
Turn the ignition on.
Connect a 12-volt test light between the Driver Window Up Driver and the Driver
Window Down Driver circuits in the motor connector.
Press the Driver Window Switch UP and DOWN.
Does the test light illuminate brightly when the switch is in either position?
All
Yes → Replace the Driver Power Window Motor.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 10
10 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C2 connector.
Measure the resistance of the Driver Window Down Driver circuit between the BCM
C2 connector and the Motor connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 11
No → Repair the Driver Window Down Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
11 Turn the ignition off.
Disconnect the Window Motor connector.
Disconnect the BCM C2 connector.
Measure the resistance of the Driver Window Up Driver circuit between the BCM C2
connector and the Motor connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Driver Window Up Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
341
POWER WINDOWS
DRIVER WINDOW HALL EFFECT FAILURE — Continued
To Next Page
Loading...
